Both sides previous revision Previous revision Next revision | Previous revision | ||
hpl3:tutorials:texture_dds_export [2012/12/18 09:52] nebej [Steps] |
hpl3:tutorials:texture_dds_export [2013/01/08 15:29] (current) nebej [Steps] |
||
---|---|---|---|
Line 93: | Line 93: | ||
- | {{:hpl3:tutorials:rltb.png}} | + | {{:hpl3:tutorials:rltb.png?nolink&}} |
- | [[{{:hpl3:tutorials:layers.png?nolink&}}]] | + | **2) Downscale the image** |
- | **2) Downscale the image** | + | If your image is to large in size it is a good idea to downscale it. Place each side on its own layer. |
- | If your image is to large in size it is a good idea to downscale it. To downscale correctly make sure that each side is on its own layer and then select Image > Image Size | + | {{:hpl3:tutorials:layers.png?nolink&}} |
+ | |||
+ | |||
+ | Select Image > Image Size… | ||
Line 116: | Line 119: | ||
{{:hpl3:tutorials:dds.png?nolink&}} | {{:hpl3:tutorials:dds.png?nolink&}} | ||
+ | |||
+ | **3) Set correct Wrap Mode** | ||
+ | |||
+ | |||
+ | After setting the cube map to a material select ClampToEdge as the Wrap Mode. This will remove all edges. | ||
+ | |||
+ | {{:hpl3:tutorials:clamptoedge.png?nolink&}} |